tm9-801.com

Posted: **Wed Dec 28, 2016 2:14 pm**

Was warm enough to work in the garage so I got to put some time into the front axle, passenger side. Only one small issue.

Brakes and cylinder removed, brake 'spider' also off.

: 20161227_173252.jpeg (93.29 KiB) Viewed 5278 times

: 20161227_173256.jpeg (86.02 KiB) Viewed 5278 times

Next are the brake plate bolts and off it comes... look at that machined surface!!

: 20161227_173639.jpeg (58.93 KiB) Viewed 5277 times

: 20161227_173644.jpeg (98 KiB) Viewed 5278 times

Looking into the hub, business end of the CV joint/stub axle.

: 20161227_173634.jpg_rot.jpeg (63.3 KiB) Viewed 5278 times

Look at the beefy old axle!

: 20161227_173915.jpeg (38.52 KiB) Viewed 5277 times

Posted: **Wed Dec 28, 2016 2:20 pm**

This is where the only issue arose... a good nick in one of the kingpin cap bolts.
Took a file and filed it down so the shims would come off.

: 20161227_174148.jpeg (41.2 KiB) Viewed 5277 times

Disconnect the tie rod. The pin was tight and it doesn't seem that there was any grease in there... so a good cleaning of the grease grove is in order when its reassembled.

: 20161227_180101.jpeg (90.21 KiB) Viewed 5277 times

Hub off looking at the knuckle.

: 20161227_180333.jpeg (28.75 KiB) Viewed 5277 times

: 20161227_180330.jpeg (55.17 KiB) Viewed 5277 times

: 20161227_180338.jpeg (69.92 KiB) Viewed 5277 times

All in all took about an hour to tear down going slow and mostly playing with the dogs than working. Still need to take the bearing out and check them.. if they are good they are going back in. Inner seals will stay, knuckle felt will be replaced.. but all in all everything (except the one stud) is in good shape so far.

tm9-801.com

Front axle semi tear down

Front axle semi tear down

Re: Front axle semi tear down