PANEL CV-3659928

[pfarber]

So I need to make some panels... specifically PANEL CV-3659928 All except NN NQ NX YN Mine are pretty beat and rusted.

aa.JPG (34.62 KiB) Viewed 6496 times

Item AA in the figure.

TWO 4x8 sheets of 20gauge CRS is a whopping $75!!!!! $35 for each. It should only cost about $40 -50 to have the panels cut and punched. Man steel is CHEAP!

[pfarber]

Got the steel from NIVERT Steel Co. There actually is a closer steel supply, KANE Steel, but they are assholes. Even when I asked around everyone said the same thing... they are assholes and overpriced. Evidently they only supply large shops in the area and anything less than a truckload is a waste of their time.

I have the two sheets laying on my racking... since I am nowhere near ready to get at the cab this is a back burner project.

[pfarber]

It seems that the all metal panel was a military only thing. The Master Parts book says:

side2.JPG (58.6 KiB) Viewed 6490 times

side1.JPG (27.65 KiB) Viewed 6490 times

Its a pad of some sort.. either way I need some made out of steel.